Support
Choose language
Actuators for Vector Fins™

Actuator kit for Vector Fins™ VF1350

90mm shaft, for VF1350 stabilizer fins

  • 360° INSTALLATION 360° INSTALLATION
    360° INSTALLATION

    360° INSTALLATION

    Designed to fit in small and challenging installation areas, the Vector Fins™ unique cone shaft design allows you to utilize the space onboard to install the actuators in any direction and insert the fins into the position you require.

  • S-LINK™ S-LINK™
    S-LINK™

    S-LINK™

    S-Link™ is a CAN-based control system used for communication between Sleipner products installed on a vessel.

    • Compact and waterproof plugs
    • Keyed and color-coded connectors to ensure correct and easy installation
    • Different cable lengths, extenders and T-connectors makes the system scalable and flexible to install
  • HYD HYD
    HYD

    HYD

    Powered by hydraulic pressure.

Item code: SPS92B

The height inside a boat is often a critical measurement when installing stabilizing systems in modern boats.

Sleipner's SPS92 actuators for Vector fins™ are up to 75 percent more compact than others, constructed for easy installation and minimal noise reproduction. 
 

70-0 ft.
70-0 ft.

Silent and Reliable Construction 

Illustration of technical design benefits of the SPS66 actuator kit.png

Technical design benefits

  • Precision machining and assembly secures a long lifetime and durability.
  • No additional center lock. This is automatic in the standard hydraulic system – very safe due to the hydraulics having extreme safety limits – actually stronger than the shaft.
  • Dual cylinders provide a balanced load, unlike single-cylinder solutions and less bearing load, allowing for a more compact shaft bearing assembly.
  • Purpose-designed dual shaft sealing - superior to standard Simmer Ring lip seals.
  • Internal hydraulic connections on actuators are pre-fitted. The installer only fits non-moving hoses/pipes - Easier and safer.
  • No complex adjustments are required to set up a controller with lots of factors. These are set automatically on the first sea-trial of the boat.
  • Bearing the lifetime lubricated SKF high-load bearings transferring the cylinder forces to the fins, have a built-in tightening system. This means that when you on most brands often need to change all bearings to remove a small noise from minimal bearing wear, you can instead tighten them again and keep going—saving both cost and hassle to get the bearings changed.
  • Vector fins are easily and quickly installed and removed from the outside for best convenience, such as transport or other haul-out situations.
  • Defined shaft-shear point in cDefined shaft-shear point in case of the fins accidentally hitting something.
  • All wet parts are made of stainless steel.

Size comparison

Size from side view compared to other brand actuators for similar fin size:

Sleipner SPS66 actuator size comparison with other brands

Properties

360° INSTALLATION

360° INSTALLATION

Designed to fit in small and challenging installation areas, the Vector Fins™ unique cone shaft design allows you to utilize the space onboard to install the actuators in any direction and insert the fins into the position you require.

S-LINK™

S-LINK™

S-Link™ is a CAN-based control system used for communication between Sleipner products installed on a vessel.

  • Compact and waterproof plugs
  • Keyed and color-coded connectors to ensure correct and easy installation
  • Different cable lengths, extenders and T-connectors makes the system scalable and flexible to install
HYD

HYD

Powered by hydraulic pressure.